Get an Estimate

Service area, Kern County

Heat pumps for Oildale homes, CA

Heat pump installation, replacement, furnace-and-AC conversion and repair in Oildale, planned for older houses north of the Kern River and priced in writing.

Last Updated:

Single-story stucco house from the 1950s on a quiet Oildale street, with a new heat pump on a pad in the side yard and the morning sun on the front lawn
CZ13Title 24 climate zone (CEC)
GasSoCalGas
PermitChecked for each address before we file
66%of homes built before 1980 (U.S. Census Bureau, ACS 5-year)

Why people call about heat pumps in Oildale

The AC is old and the furnace is next

If the house still has a gas furnace in a hall closet and an AC condenser outside, and both are near the end, one heat pump can take over both jobs.

The house was built before ducts were planned for cooling

In a house from the 1940s or 1950s, the ducts and return were often sized for heat alone. We check airflow before we size anything.

The panel is older than the AC

A heat pump and air handler need their own circuits. We check the panel on the first visit, because it decides more of the price than any other item.

A unit that runs all afternoon in July

Long run times and a dusty coil wear a system down fast. Sometimes it is a repair; sometimes it is the end of the system.

Oildale houses, and what that means for a heat pump

Oildale’s houses are older than Bakersfield’s, so the panel, the return, the ducts and the outdoor spot decide a heat pump job here more than the equipment does. At Veranda Bakersfield Heat Pumps, we check all four before we quote.

Oildale sits just north of Bakersfield across the Kern River. U.S. Census Bureau figures put about two-thirds of Oildale’s homes before 1980, and nearly four in ten before 1960. In a house that age, you usually find:

  • A gas furnace in a hall closet or the garage.
  • An AC condenser added later in the side yard.
  • Ducts and a return sized for heating alone.
  • An electrical panel older than both.

None of that rules out a heat pump. It means the visit starts with the house, not with a brochure, and the written estimate shows what each of those four things adds.

Why the panel comes first in Oildale

A heat pump needs its own circuits, and in a 1950s Oildale house the panel is often the oldest part of the system. So we open the panel door before we talk about equipment.

A furnace-and-AC conversion needs a 240-volt circuit for the air handler, and every heat pump needs its own disconnect at the outdoor unit. What we find at the panel sets the next step:

What we find at the panel What it means for your estimate
Room for the new circuit No panel line, and the job stays closer to the low end of our range
A full panel We show you the options and price the change as its own line
A panel near the end of its life We tell you on the visit and price the upgrade separately

The electrical guide explains which circuits a heat pump needs and why. Our heat pump installation page shows where the electrical work fits in the whole job.

Ducts and returns in older Oildale homes

Ducts in an older house were laid out for a furnace that ran a few hours on a winter evening. A heat pump runs longer and moves more air through a long Bakersfield afternoon, so the return has to keep up.

We test airflow at the registers and look at the duct runs in the attic or crawlspace. A sound duct system stays. These get fixed, each priced on its own line:

  • A loose return connection that pulls attic air.
  • A crushed or torn supply run.
  • A return grille and duct too small for the new system.

That is usually what decides whether the back bedroom ever cools down. The ductwork guide covers what we look for and why static pressure matters.

Where the outdoor unit goes on an Oildale lot

We set it with the clearances its instructions call for, away from bedroom windows where the lot allows, and where the condensate has somewhere to drain. If the old spot is a poor fit, we find a better one.

A narrow side yard against a west-facing wall holds heat late into the evening, and a condenser parked there breathes that hot air all afternoon. A heat pump also runs through the winter, so the spot matters in both seasons. The placement guide covers sound, clearances and drainage.

Utilities and the permit

PG&E supplies electricity in Oildale and SoCalGas supplies gas. A conversion caps the gas line at the old furnace; if a water heater or range still uses gas, that service stays.

Heat pump installation and replacement need a permit and an inspection. The permit office depends on the address; we check it before the permit is filed, by the parcel rather than the Bakersfield mailing address many Oildale homes use. The permit is a line in the written estimate, never a surprise afterward. The permits guide explains the inspection.

When a conversion makes sense

When the AC is failing and the furnace is not far behind. One heat pump heats and cools, and Bakersfield’s mild winters with cold valley mornings are easy work for it.

Veranda’s typical range for a furnace-and-AC conversion is $8,000 to $15,500. The panel decides the most, and the Oildale conversion below shows where one house landed and why. The conversion guide explains each step, and our furnace-to-heat-pump conversion page covers what the job includes.

What to have ready for the visit

Clear a path to the panel, the furnace closet or garage, and the attic or crawlspace hatch. Then tell us a few things about the house:

  • How old the furnace and the AC are, if you know; we read the nameplates either way.
  • Which rooms stay warm on a summer afternoon or cold on a winter morning.
  • Any past work on the panel, the wiring or the ducts.
  • Whether the water heater and the range use gas, so we know what stays connected.

The replacement checklist lists the rest, and the replacement cost guide shows what moves the number.

If your system is newer and just not keeping up

Start with heat pump repair or a maintenance visit. We would rather fix the right part than sell you a system you do not need yet.

A newer system that struggles can have a dusty coil, a refrigerant charge problem or a crushed duct, and each of those is a repair. If it stops on a hot afternoon, call us; emergency heat pump repair explains how those calls work. We also work in nearby Rosedale and Shafter.

Services in Oildale

New heat pump air handler in the hall closet of a 1950s Oildale house where the gas furnace used to stand
Oildale

An Oildale furnace and AC conversion

The AC in this 1950s Oildale house was failing, the gas furnace in the hall closet was not far behind, and the owners did not want to pay to replace two systems. They wanted one system that heated and cooled, and no gas appliance next to the bedrooms.

What we did and why

On the visit we checked the panel first, because a conversion needs a 240-volt circuit for the air handler. It had two open spaces, so the job did not need a panel upgrade, which kept it in the lower half of our conversion range.

The ducts were in good shape apart from a loose return connection, so we kept them and sealed the return rather than replacing ductwork that still worked.

Where
Oildale
Job
Furnace and AC conversion
House
1,300 sq ft, built in the 1950s
Equipment
Matched heat pump and hall-closet air handler
Electrical
New 240-volt circuit; the panel had room
Price
$12,400
On site
2 days

How the job ran

On the first morning we removed the furnace and the old condenser, capped the gas line at the closet and protected the hallway. That afternoon the new air handler went into the closet and the heat pump onto a new pad in the side yard.

On the second day we ran the new circuit, connected the refrigerant lines and sealed the return. Then we started the system, checked airflow and the heating mode, and walked the owners through the new thermostat.

One electric system now heats and cools the house and the closet no longer holds a gas appliance. The conversion took two days on site and came to $12,400, inside Veranda's typical conversion range.

How a job usually runs in Oildale

Call

Tell us what heats and cools the house now, roughly how old it is and where it is in Oildale.

Visit

We walk the house, check the panel, the ducts and the return, and look at where the outdoor unit can sit on the lot.

Written estimate

The equipment, its size and why, any panel or duct work, the permit for your address, removal and startup, with options priced separately.

Install and startup

We set and connect the system, check airflow and both modes, and leave you the startup readings.

Neighborhoods, landmarks and routes

  • North Chester Avenue
  • Roberts Lane
  • Airport Drive
  • Norris Road
  • Oildale Drive

Landmarks

  • Meadows Field Airport
  • Kern River
  • North High School

Getting around

  • Highway 99 on the west side
  • Highway 65 north toward Porterville
  • North Chester Avenue across the Kern River into Bakersfield
10 mi20 mi30 miBakersfieldN ↑OildaleArvinLamontRosedaleShafterWasco
Open Oildale, CA in Google Maps

Planning a heat pump in Oildale?

We start with what heats and cools the house now, where the outdoor unit can go and what the permit office asks for.

Oildale: questions

What does a furnace-and-AC conversion cost in an Oildale house?

Veranda's typical range for a furnace-and-AC conversion is $8,000 to $15,500. The panel decides the most. A panel with room for the new circuit keeps the job toward the lower end, as in our Oildale conversion at $12,400; a panel upgrade pushes it up. You get the number in writing after the visit.

My Oildale house is from the 1950s. Can it take a heat pump on the existing ducts?

Often, yes. We test the ducts and check the return on the visit. Sound ducts stay, and a loose connection or a crushed run is priced as its own line. A return sized only for heating is the thing we check hardest.

Do I need a new electrical panel for a heat pump in Oildale?

Not always. The air handler needs a 240-volt circuit and the outdoor unit its own disconnect. If the panel has room, there is no panel upgrade. If it is full or very old, we tell you before you commit and price the upgrade separately.

Who handles the permit for a heat pump in Oildale?

We do. The permit office depends on where the parcel sits, not on the mailing address, so we check your address before the permit is filed. The permit and inspection are listed in the written estimate.

Do you come to Oildale for emergency heat pump repairs?

Yes. Call us, tell us what happened and whether anyone at home is vulnerable to heat, and we tell you on the phone when we can get there and what to do in the meantime.

Nearby service areas

Guides for houses in Oildale

Get an estimate in Oildale

Tell us what heats and cools the house now and where it is in Oildale.

Step 1 of 2

The house and the work