Get an Estimate

Free tool

Heat pump cost estimator

Pick the job and tick what applies to your house. You see our typical range and where a job like yours tends to land. Nothing is sent unless you choose to.

Describe the job

What are you planning?
Do some ducts or the return need work?

One room that never cools, weak airflow or a crushed run in the attic count as yes.

Is the electrical panel full or old?

Not sure is fine. We open the panel on the visit.

Is access hard?

A tight attic, a crawlspace, a roof unit or a narrow side yard.

Is the house large, or does it have more than one system?
Do you want higher-efficiency or variable-speed equipment?

Veranda's typical range

$6,500 to $15,500Like-for-like ducted replacement

Lower part of our range.

A straightforward swap with ducts and panel in good shape sits at the lower end.

What we check on the visit

  • Duct or return work: priced as its own line after we test airflow.
  • Panel work: a new circuit fits most panels with room; a full or old panel adds an upgrade line.

We never count a rebate in your price until it is approved. When one applies, it shows on its own line.

Get your written estimate

Where do these numbers come from?

These are Veranda Bakersfield Heat Pumps's own typical ranges, and the estimator shows nothing else:

  • Like-for-like ducted heat pump replacement: $6,500 to $15,500
  • Furnace and AC conversion to a heat pump: $8,000 to $15,500

Nothing is scaled by size and no line is invented. The ticks only show whether a job like yours tends to sit in the lower part, the middle or the upper part of the range. The price for your house comes in a written estimate after the site visit.

What moves the price?

Duct or return work, a full or old panel, hard access, a larger house or a second system, and higher-efficiency equipment. The cost guide goes through each one with three typical budgets, and the fit assessment helps if you are not sure which job you need.

Cost estimator: questions

Why does the cost estimator not ask for square footage?

Because square footage does not set the price on its own. We size the system from a load calculation of the house, and the estimate follows from that, the ducts and the panel.

How do you price a new ducted system?

From the load calculation and the duct design for your house, after the site visit. The estimator lists the things that move that price, and the written estimate prices each one.

Does the cost estimator include rebates?

No. We never count a rebate in your price until it is approved. When a program applies to your address and equipment, it shows on its own line in the written estimate.

Get the exact number

Book the site visit. We check the ducts, the return and the panel, then put the price in writing.

Step 1 of 2

The house and the work